McIntosh MC602 - Manual (Page 18)

18
Specifications
Specifications
Power Output
Minimum sine wave continuous average power output per
channel, all channels operating is:
600 watts into 2 ohm load
600 watts into 4 ohm load
600 watts into 8 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% for 2, 4 or 8 ohm loads
Dynamic Headroom
2.1dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
2.45 Volts Balanced Input
4.9 Volts Unbalanced Input
A-Weighted Signal To Noise Ratio
93dB Unbalanced (120dB below rated output)
97dB Balanced (124dB below rated output)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 2, 4 or 8 ohm loads
Input Impedance
10,000 ohms Balanced or Unbalanced Inputs
Wide Band Damping Factor
100 @ 8ohms
Power Requirements
100 Volts, 50/60Hz at 18 amps
110 Volts, 50/60Hz at 16.5 amps
120 Volts, 50/60Hz at 15 amps
220 Volts, 50/60Hz at 8.2 amps
230 Volts, 50/60Hz at 7.8 amps
240 Volts, 50/60Hz at 7.5 amps
Note: Refer to the rear panel of the MC602 for the correct
voltage.
Dimensions
Front Panel: 17-3/4 inches (46cm) wide, 11 inches (28cm)
high. Depth behind front mounting panel is 19-5/8 inches
(49.83cm). Clearance required in front of the Front Panel is
1-3/4 inches (4.5cm) for handles.
Weight
155 pounds (70.31kg) net, 180 pounds (81.65kg) in ship-
ping carton