Metrologic Instruments MS6130 MX003 - Manual (Page 8)

4
C ONNECTIONS OF THE “MX” I NTERFACE TO THE H OST D EVICE
Except version 17
1. Turn off the host system.
2. Connect the MCA to the host device. Connect the “MX” interface to
the MCA.
3. Check the AC input requirements of the transformer to make sure the
voltage matches the AC outlet. The socket outlet should be near the
equipment and easily accessible.
4. Plug the transformer into the side of the MCA and the AC outlet.
5. Power up the host system.
Figure 2: Connecting the “MX” (through the MCA) to a host device
To maintain compliance with applicable standards, all circuits connected
to the unit must meet the requirements for SELV (Safety Extra Low
Voltage) according to EN 60950.
Transformer
“MX” Scanner Interface
MCA
Host System
MS6130 with Liberty ® RF
Scanner Interface
(Transmitter)