Makita LS1212 - Manual (Page 21)

21
Example:
In the case of cutting 52/38
° type crown molding for
position (1) in Fig. A:
• Tilt and secure bevel angle setting to 33.9
°
LEFT.
• Adjust and secure miter angle setting to 31.6
°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on
the saw.
• The finished piece to be used will always be on
the LEFT side of the blade after the cut has
been made.
In the case of right bevel cut
Example:
In the case of cutting 52/38
° type crown molding for
position (1) in Fig. A:
• Tilt and secure bevel angle setting to 33.9
°
RIGHT.
• Adjust and secure miter angle setting to 31.6
°
RIGHT.
For inside
corner
For outside
corner
Molding
position in Fig. A
(1)
(2)
(3)
(4)
52/38˚ type
Right 33.9˚
45˚ type
Right 30˚
52/38˚ type
Right 31.6˚
Left 31.6˚
Right 31.6˚
45˚ type
Right 35.3˚
Left 35.3˚
Right 35.3˚
Bevel angle Miter angle
Table (A)
For inside
corner
For outside
corner
Molding
position in Fig A
(1)
(2)
(3)
(4)
Molding edge against
guide fence
Wall contact edge should be
against guide fence.
Ceiling contact edge should be
against guide fence.
Wall contact edge should be
against guide fence.
Finished piece
Finished piece will
be on the Right
side of blade.
Finished piece will
be on the Left side
of blade.
Table (B)