Side grip (auxiliary handle) (accessory), Hex wrench storage – Makita MT560 User Manual

Page 9

To install the blade, follow the removal procedure in reverse.
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.

CAUTION:

•

The inner flange has a 20 mm diameter on one side and
a 19 mm diameter on the other. The side with 19 mm
diameter is marked by “19”. Use the correct side for the
hole diameter of the blade you intend to use. Mounting
the blade on the wrong side can result in the dangerous
vibration.

Side grip (auxiliary handle) (Accessory)

Align the hole in the grip holder with the hole in the blade
case (upper blade guard) and secure the grip holder onto the
blade case using the screw as shown in the figure. Securely
screw the side grip clockwise into the hole in the grip holder.

Hex wrench storage

When not in use, store the hex wrench as shown in the figure
to keep it from being lost.

1. Hex bolt

2. Outer flange

3. Saw blade

4. Inner flange

004032

1. Mounting shaft

2. Inner flange

3. 19mm marking

4. Saw blade

5. Outer flange

6. Hex bolt

004033

004034

004035

This manual is related to the following products:

MT580