Musical Fidelity X-T100 - Manual (Page 10)

X-T100
AMPLIFIER SPECIFICATIONS
Issue 4: 2 nd October 2006
Output: Power 50 Watts per channel into 8 Ohms (17dBW)
80 Watts per channel into 4 Ohms
Voltage, RMS >20 Volts 20Hz to 20 kHz
Voltage, Peak-to-peak 67 Volts
Current peak-to-peak 30 Amps
Damping factor 80
Output devices per channel 2
Pre-out impedance 47 Ohms
Line inputs:
THD + noise, 20Hz to 20 kHz < 0.01%
Signal / noise ratio > 98dB ‘A’-weighted
Input sensitivity for 70 Watts 172mV
Input impedance 220k Ohms
Overload margin 26dB
Channel separation > 80dB typical
Frequency response 20Hz to 20 kHz, +0, -0.2dB
Phono
input: RIAA/IEC combined response
-20.0
-15.0
-10.0
-5.0
0.0
5.0
10.0
15.0
20.0
20.0 31.5 50.0 80.0 125 200 315 500 1000 1600 2500 4000 6300 10000 16000
RIAA
PHONO
RIAA/IEC
PHONO RESPONSE
Frequency (Hz)
dB
Signal / noise ratio > 96dB ‘A’-weighted
Input sensitivity 2.5mV (moving magnet)
Input impedance 47k Ohms
Overload margin 24dB
Connections:
Line level inputs: 3 pairs line level RCA connectors,
1 front panel 3.5mm jack socket (sharing AUX1 input)
1 pair phono (MM) RCA connectors,
Line level outputs: 1 pair RCA [preamp] controlled by the volume,
1 pair RCA [tape record] fixed line level output.
Speaker outputs: 1 pair 4mm banana plug/binding posts per channel.
Power requirement: For use only with suitable Musical Fidelity power supply e.g. Triple-X.
(A Triple-X unit is included with XT-100 amplifier)
Weight:
3.85 kg, 8.5 lbs unit only, unboxed
11 kg, 24.2 lbs in shipping carton (including triple-X PSU)
Dimensions:
219 mm, 8.6 inches wide.
88 mm, 3.5 inches high including feet
360 mm, 14.2 inches deep including terminals
Standard
accessories: Triple-X PSU
(See TRIPLE-X manual for further information on the power supply unit)
Musical Fidelity reserves the right to make improvements which may
result in specification or feature changes without notice.
Page 10 of 11