Minuteman UPS PRO-E - Manual (Page 13)

12
English
Possible Cause Symptom What To Do
Press and release the On/Off/
Test button to start UPS On/Off/Test button not
pushed UPS will not turn on
Reset circuit breaker by
pressing the plunger back in.
If the AC circuit breaker trips
after UPS starts up, reduce
the load on the UPS UPS operates in
battery mode only,
even though there is
normal AC present Input AC circuit breaker is
tripped
UPS has detected an
internal fault Call for service Fault LED is
illuminated
The On-line/On-
Battery LED is
illuminated, but
there is no output
Incorrect service wiring
Disconnect the computer
cable from the UPS and press
the On button. If UPS works
normally, the software has
control of the UPS The UPS is being
controlled via its
communications port
Site Wiring Fault
LED is illuminated Have a Qualified Electrician
correct the service wiring
The batteries may be weak
or at the end of useful
service life Charge the batteries for 8
hours and retest. If the runtime
is still less than expected, the
batteries may need to be
replaced, even though the
Weak/Bad Battery LED is not
illuminated UPS does not
provide expected
runtime
Weak/Bad Battery
LED is illuminated
Overload LED is
illuminated and a
constant alarm
The On-Line LED is
blinking and the au-
dible alarm is silent
UPS occasionally
emits a beep
Weak/bad batteries or bad
connections at the battery
Normal operation
The load has exceeded the
UPS's capacity
The UPS is in either the
Boost mode or the Buck
mode
Check battery connections,
charge the batteries for 8
hours, replace the batteries
The UPS is performing its
intended function
Check the specifications (see
section 8). Remove part of the
load
The UPS is performing its
intended function