Muratec MFX-2500 - Manual (Page 13)

1.5
Getting started
Acceptable document size
The acceptable dimensions as follows:
•In the Automatic Document Feeder(ADF)
•On the Flatbed Scanner(FBS) glass
Automatic document feeder ( ADF ) (width
×
length)
S INGLE - SHEET M ULTIPLE - SHEET
Maximum: 300 mm × 900 mm 297 mm × 420 mm
Minimum: 120 mm × 100 mm 148 mm × 105 mm
Weight: 30.2 – 104.7 g/m 2 52.3 – 104.7 g/m 2
You can set up to about 50 sheets of A4-, 40 sheets of B4- or 30 sheets of A3-sized
document in the ADF at a time.
Flatbed scanner ( FBS ) glass (width × length)
Maximum: 297 mm
×
420 mm
Things not to put in your fax
To avoid paper jams and damage to your machine, don’t insert:
• Folded, curled, torn, wrinkled or very thin pages
• Documents with staples, glue, tape, paper clips or still-wet correction fluid
• “Sticky notes” (or documents with “sticky notes” attached)
• Cardboard, newspaper or fabric
• Pages with duplicating carbon on either side
• Credit cards or any small, thick items
How to set the document
When setting the documents in the Automatic Document Feeder
1 Align your document to the rear left corner.
2 Adjust the document guide to fit your docu-
ments.
3 Set your document face up into the docu-
ment feeder.
Note: You cannot set the different sized docu-
ment at a time.
When setting the documents on the FBS glass
1 Lift the platen cover fully.
2 Set your document face down
on the
FBS glass. The document
should be aligned to the rear
left corner.
3 Gently close the platen cover.
Note: If you do not lift the platen
cover fully before close it, the
document size will not be detected automatically.
Auto document size detection
The following sized documents are automatically detected.
• A3
• B4
• A4
• B5
• A5
Feed direction
Some guidelines