Magnadyne M5100CD - Manual (Page 5)

Select a Disc
1. Load your CD Changer with compact discs per
the manufacturer's operating instructions.
2. Press the SHIFT button (15) to enter Shift
Mode. “SHIFT” will then appear in the display,
indicating the CD Changer is active.
3. Press the TRK/TUNE DN or TRK/TUNE UP (5)
button to scroll through the CD’s loaded in the CD
Changer. If there isn’t any operation for several
seconds, the unit will exit Shift Mode automatically.
Notes on CD-Rs and CD-RWs:
• The unit cannot play a CD-R and CD-RW that is
not finalized. (Please refer to the manual of your
CD-R/CD-RW recorder or CD-R/CD-RW software
for more information on the finalizing process).
• This unit will not play MP3 music or WMA music
recorded on any CD-R or CD-RW disc.
• Be sure to only use discs with the following labels
in this unit:
5
General Operations
Setting the Clock
1. Press DISP button (13) for more than 3 seconds
until the clock shown in the display area is flashing.
2. Press the TRK/TUNE DN button to adjust the
hours
3. Press the TRK/TUNE UP button to adjust the
minutes.
Display Priority
Clock Display Priority
Press and hold DISP button (13) while pressing
the TRK/TUNE DN button to select Time Priority.
Pressing the DISP button while in Time Priority
will temporarily display selected station frequency.
In CD Mode:
When the display priority is set to “Time”, the
time will be displayed.
Pressing DISP button will temporarily display CD
track number, time remaining or elapsed time
depending on current CD display option selected.
After 5 seconds the display will return to the clock.
Frequency Display Priority
Press and hold DISP button while pressing the
TRK/TUNE UP button to select Frequency
Priority. Pressing DISP button while in Frequency
Priority will temporarily display clock.
In CD Mode:
When the display priority is set to “Frequency”,
the CD track number will be displayed.
Pressing the DISP button will temporarily display
the clock. After 5 seconds the display will return
to the CD display.
Selecting a Mode
Press the MODE button (3) to step sequentially
through the following sources: Radio Mode to
Radio Tuner > CD > CD Changer (optional) >
Auxiliary > Radio Tuner.
Illumination Dimmer
Press LOUD/DIMMER button (2) for more than 2
seconds to adjust the brightness of the LCD
display backlight.
Reset Button (20)
The Reset Button (21) is located behind the
Waterproof CD Cover (22) and above the CD Slot.
Activate the reset button with either a ballpoint
pen tip or paper clip for the following reasons:
• After initial installation of the unit is completed.
• When the function buttons do not operate.
• Error symbol in the display.
If there is a disc in the slot when the reset button
is pressed the disc will be ejected.
CD Changer Operation (Optional)
SCAN
M5100CDUMFinal 2/1/05 4:58 PM Page 5