MIDLAND WR-100 Owner Manual - Manual (Page 8)

WR-100 Owner’s Manual
Page 8 www.midlandradio.com
3. Go to the Midland Radio Corporation website at www.midlandradio.com
• Click on the weather radio link at the top of the page.
• At the top of the weather radio page will be the link to the NWS list of
states and corresponding county codes. Click on the link.
• Click on your state and a list of counties and codes will be listed. Locate
your county and then find your code.
Programming S.A.M.E. Codes into the WR-100: Programming S.A.M.E. Codes into the WR-100:
“ANY” S.A.M.E. County Codes is the Default Factory Setting: Your WR-
100 weather radio comes preprogrammed to receive NWS weather and haz-
ard alert transmissions for all S.A.M.E. county codes within range. If this is
what you want, leave the radio set to “ANY.”
A Single S.A.M.E. County Code:
Press “MENU” button to open menu options.
• Press the “UP” arrow to scroll through menu options until “S.A.M.E.
SET” is displayed, then press “SELECT” button.
• Press the “UP” arrow to scroll through: “SINGLE”, “MULTIPLE”, or
“ANY.”
• Display “SINGLE”, then press “SELECT.” “S.A.M.E.01” will be displayed.
(Note if you are programming a single S.A.M.E. County Code, only the
“01” setting will be used.) Press “SELECT”.
• Using the “UP” arrow, find the first digit of your S.A.M.E. County Code.
Press the “RIGHT” arrow to save the digit and automatically
advance to the next digit.
• Program all digits of your S.A.M.E. County Code in the same way.
• Press “SELECT” to store your S.A.M.E. County Code. Press “MENU”
to close the programming menu.
Helpful Tip: The S.A.M.E. code is created using the following method:
• The first digit is the subcounty code-currently 0 in most areas.
• The second two digits represent the state code.
• The last three digits represent the county code.