MTD 450 - Manual (Page 13)

13
8
• Remove the belt keeper bracket located behind the
engine pulley by removing two hex bolts and lock
washers. See Figure 8-1.
• Remove belt and reassemble new belt. Follow
instructions in reverse order.
NOTE: Upon reassembly, make certain the belt is
routed over the idler pulley and inside of belt keepers by
engine pulley. See Figure 8-1.
Off-Season Storage
If the tiller will not be used for a period longer than 30 days,
the following steps should be taken to prepare the tiller for
storage.
• Clean the exterior of engine and the entire tiller
thoroughly. Lubricate the tiller as described in the
lubrication instructions.
• We do not recommend the use of pressure washers
to clean your unit. They may cause damage to
electric components, spindles, pulleys, bearings or
the engine. The use of pressure washers will result
in shortened life and reduce serviceability.
• Refer to the engine manual for correct engine
storage instructions.
• Wipe tines with oiled rag to prevent rust.
• Store tiller in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in an
unventilated or metal storage shed, care should be taken
to rustproof the equipment. Using a light oil or silicone, coat
the equipment and especially any springs, bearings, and
cables.
Idler Pulley Rod
Belt Keeper
Bracket Idler Bracket
Engine Pulley
Figure 8-1
Off-Season
Storage
NOTE: Specifications are
subject to change without
notification or obligation.
Images my not reflect your
exact model and are for
reference purposes only.
When storing any type
of power equipment
in an unventilated or
metal storage shed,
care should be taken
to rustproof the
equipment. Using a
light oil or silicone,
coat the equipment and
especially any springs,
bearings, and cables.