Assembly – Makita 5007NBA User Manual

Page 9

Switch action

CAUTION:

•

Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the “OFF”
position when released.

To start the tool, simply pull the switch trigger. Release the
switch trigger to stop.

Electric brake

This tool is equipped with an electric blade brake. If the tool
consistently fails to quickly stop blade after switch trigger
release, have tool serviced at a Makita service center.

The blade brake system is not a substitute for lower guard.
NEVER USE TOOL WITHOUT A FUNCTIONING LOWER
GUARD. SERIOUS PERSONAL INJURY CAN RESULT.

ASSEMBLY

CAUTION:

•

Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.

Removing or installing saw blade

CAUTION:

•

Be sure the blade is installed with teeth pointing up at
the front of the tool.

•

Use only the Makita wrench to install or remove the
blade.

To remove the blade, press the shaft lock so that the blade
cannot revolve and use the wrench to loosen the hex bolt
counterclockwise. Then remove the hex bolt, outer flange
and blade.

1. Switch trigger

001396

1. Wrench

2. Shaft lock

001417