Troubleshooting warranty – MidiLand 8200 User Manual

Page 10

Three Years Limited Warranty

MidiLand, Inc. warrants to the end user that the S4 MidiLand

8200 v2.0 is free from defects in materials and workman-

ship in the course of normal and reasonable use for a term of Three (3) years from the date of purchase.

This warranty is the exclusive and only warranty in effect relative to MidiLand, Inc. S4 MidiLand

8200 v2.0 and any

other warranties, either expressed or implied, are invalid. Neither MidiLand Inc., nor any authorized MidiLand, Inc. reseller
is responsible for any incidental damages incurred in the use of the S4 MidiLand

8200 v2.0. (This limitation of incidental

or consequential damage is not applicable where prohibited).

MidiLand, Inc.s obligation under this warranty does not apply to any defect, malfunction or failure as a result of misuse,
abuse, improper installation, use with faulty or improper equipment of the use of the S4 MidiLand

8200 v2.0 with any

equipment for which it is not intended.

The terms of this warranty applies only to the S4 MidiLand

8200 v2.0 when such product is returned to the respective

authorized MidiLand, Inc. reseller where purchased. Under the terms of the warranty the original consumer purchaser has
certain legal rights and may have other rights which vary worldwide.

1 0

TROUBLESHOOTING

WARRANTY

For further information or support, e-mail us at [email protected] or visit our FAQ page at www.midiland.com.

PROBLEM

POSSIBLE SOLUTION

No sound output

Please check and make sure if the correct input mode on the ADS 4000 has been

selected to match the output on the sound source.

Check and make sure the systems wire connections are secured and that you have

connected the input into the correct output on the sound source.

Make sure the ADS 4000 unit is not muted.

Make sure the sound card is not muted (please refer to the sound cards manual).

Make sure your sound source is fully functioning.

ADS 4000 is not functioning

properly

Turn off the system and unplug the AC adapter from the unit and the power

outlet. Wait for one minute before replugging the adapter so the unit can reset.

Remote control is not

functioning

Change the battery on the remote control.

Make sure the ADS 4000 unit is functioning properly.

Constant buzzing/static

sound and no music

Place the input cable away from any power cables. If the problem persists, please

contact MidiLand tech support for assistance.