Macsense Connectivity AeroPad Mini - Manual (Page 14)

12
3.2 Installation
To connect AeroPad Mini to your computer, following the step below:
1. Plug one RJ-45 connector of the enclosed Ethernet cable to the Ethernet
port on your computer; plug the other RJ-45 connector to AeroPad Mini's
Ethernet port.
2. Take out the USB Power cable. Plug the USB connector into a USB port on
the computer, and then plug the other end into the AeroPad Mini’s power
port. This will provide the AeroPad Mini with the required power to operate.
3. Make sure the switch on the base of the AeroPad Mini is set to "Client" mode
(default position). AeroPad Mini would not work if it is set in any other
position.
3.3 Hardware Reset
There may come a time when AeroPad Mini needs to do a hardware reset to
return all settings to factory defaults. Note that all users settings will be replaced
in a hardware reset. To do hardware reset,
1. While AeroPad Mini is powered, use a pin to poke into the Reset Switch.
Push and hold for 4 seconds then release.
2. After release, the LAN and WLAN LEDs should go off and begin a reset
process. Wait for all LEDs to settle as solid green. It may take up to 10
seconds for the process to complete.
3. Reset is now complete. There is no need to re-power the AeroPad Mini or
your computer afterwards.