Miele KM 5820 - Manual (Page 16)

Cooking with Auto-heat
When Auto heat-up has been activated,
the burner automatically turns on at the
highest setting (heat-up boost) and
then switches to the previously selected
continued power level. The heat-up
time depends on which continued
power level has been chosen (see
chart).
With higher continued power levels,
only a relatively short heat-up time is
required.
To activate Auto-heat
^ Touch the On/Off touch control for
the desired burner.
The burner display flashes.
^ Touch and hold the desired
continued power level number on the
settings bar until a signal sounds and
the Auto-heat indicator lights up.
After the heat-up time, the Auto-heat
indicator will go out.
With the extended settings (see
"Programming"),
A flashes alternately
with the continued power level until the
heat-up time has finished.
Changing the continued power level
deactivates Auto-heat.
To deactivate Auto heat-up
You can turn off the heat-up boost
before the heat-up time has elapsed.
^ Touch the On/Off touch control for
the desired burner.
The burner display flashes.
^ Touch and hold the set continued
power level on the settings bar until
the indicator light and
A go out; or set
a different power level.
Continued
Power Level*
Heat-up time
(approx.) min:sec
1 1 : 20
1. 2 : 00
2 2 : 45
2. 3 : 25
3 4 : 05
3. 4 : 45
4 5 : 30
4. 6 : 10
5 6 : 50
5. 7 : 10
6 1 : 20
6. 2 : 00
7 2 : 45
7. 2 : 45
8 2 : 45
8. 2 : 45
9 -
* The continued power level marked
with a dot are only available with the
extended power level settings (see
"Programming").
Use
16