Radio operation, Sound controls – Magnadyne M3100CD User Manual

Page 5

Radio Operation

Select a Band

In Tuner Mode, press the "BAND" button (16) to
select the desired band in the following order:
FM1, FM2, FM3, AM1, AM2. Each band can store
up to six preset stations.

Band Button

Press the "BAND" button (16) while in Radio
Mode to change to CD Mode.

Tuning

Manual Tuning: Press and hold the

button (3) for more than 4 seconds then release.
Then press and release the

button until

desired frequency is selected. The unit will default
back to Seek Tuning Mode after 5 seconds of no
button activity.

Seek Tuning: Press the

button to move

to the next station automatically.

Automatically Store Stations

Select six strong stations and store them in the
current band:
Select a Band (if needed). Press and hold the

button (11) for more than three seconds.

The new stations replace stations already stored
in that band.

Sound Controls

Preset Scan

Scan stations stored in the current band:
Select a Band (if needed). Press the button
momentarily. The radio pauses for ten seconds at
each preset station. When desired station is
reached, press the

button again to stop

scanning.

Preset Stations

Six numbered preset buttons store and recall sta-
tions for each band.

Select a Band (if needed). Select a station by
pressing the

button. Press and hold

any of the preset buttons for three seconds to
memorize the station. The preset number will
appear in the display.

Recall a Station

Select a Band (if needed). Press one of the six
preset buttons to select a stored station.

Scan

Press the button (13) to scan through strong
stations in the current band. The radio will pause
for five seconds at each strong station. To listen
to the current station, press the button again.

Audio Mode Selection Button

Selects the desired audio mode by pressing the

button (24). The modes will be displayed the

following order: Volume, Bass, Treble, Balance
and Fader.

Volume

Adjust the volume by pressing the

button.

O = Minimum Volume

46 = Maximum Volume

Initial Volume Level

To program the Initial Volume Level, adjust the
volume to the desired level, then press and hold
the PWR button for more than 3 seconds. The
next time the unit is turned on, the volume will be
at this initial level.

Bass

Press SEL button two times. Adjust the Bass up

or down by pressing the

button.

-6 = Minimum Bass
+6 = Maximum Bass

Treble

Press SEL button three times. Adjust the Treble

up or down by pressing the

button.

-6 = Minimum Treble
+6 = Maximum Treble

Balance

Press SEL button four times. Adjust the Balance

left or right by pressing the

button.

R12 = Right speakers only

C0 = Equal sound right and left

L12 = Left speakers only

Fader

Press SEL button five times. Adjust the Fader

front or rear by pressing the

button.

R12 = Front speakers only

C0 = Equal sound front and rear

L12 = Rear speakers only

M3100CDUM .qxd 07/24/03 4:17 PM Page 5