Miele G 2020 - Manual (Page 29)

With the aid of the following guide, minor problems can be fixed without a service call.
,
Repairs should only be carried out by a qualified and trained person in
accordance with local and national safety regulations. Unauthorized repairs
could cause personal injury or machine damage.
Technical faults
Issue Possible fault Solution
None of the indicators
light or flash. The machine is not
plugged in. Insert the plug.
The fuse has tripped. Reset the circuit breaker.
Make sure it is a 15 A
breaker.
The dishwasher does
not start after the
Start/Stop button was
pressed. The program selector
does not point to a
program. – Turn the program selector
to the desired program.
– Press the "Start/Stop"
button.
The dishwasher stops
during a program. The fuse has tripped. Reset the circuit breaker.
Make sure it is a 15 A
breaker.
The "Rinse", "Drying"
and "End" indicators
flash at the same
time. There may be a technical
fault. – Turn the dishwasher off s.
After a few seconds:
– Turn the dishwasher on.
– Turn the program selector
to the desired program.
– Press the "Start/Stop"
button.
If the problem persists, call
Technical Service.
The drain pump runs
when the door is
open. The waterproof system
has activated. – Turn off the water supply.
– Call Miele Technical
Service.
Frequently asked questions
29