Melissa 645-074 - Manual (Page 15)

KEY
1. Electric travel kettle
2. On switch
3. Storage space for teaspoon
4. Handle
5. Button for opening lid
6. Lid
7. Cap for storage space
8. Tea strainer
9. Teaspoon
10. Lid for storage container
11. Storage container for tea and coffee
12. Cups
13. Switch 120 V/230 V (on the bottom)
14. Indicator light
PRIOR TO FIRST USE
Before using your travel kettle for the first
time (or following a long period without use),
it should be boiled 3 times.
1. Read the safety instructions through
carefully.
2. Ensure that the cord is fully extended.
3. Remove the extra accessories from
inside the kettle.
4. Check that the switch (13) on the
underside of the kettle is set to the
correct supply voltage.
5. Fill the kettle with water up to the
maximum filling level (MAX).
6. Pour out the water once it has boiled.
Repeat the process described under points
5-6 three times.
USING YOUR ELECTRIC TRAVEL
KETTLE
1. Remove the lid (6) of your travel kettle by
depressing the button on the lid (5) while
pulling the lid up.
2. Remove the extra accessories from
inside the kettle.
3. Check that the switch (13) on the
underside of the kettle is set to the
correct supply voltage.
4. Pour fresh water into the kettle. The
kettle must be filled to the MIN mark at
least, but no higher than the MAX mark.
5. Plug the kettle in and check that it is
switched on.
6. Press the On switch (2). The red
indicator light (14) comes on and the
kettle begins to heat up the water.
The water will boil within a few minutes,
depending on the amount of water in the
kettle. If you want to halt the boiling, switch
off at the wall socket and unplug. Once the
water is boiling, the kettle will automatically
switch off thanks to the integrated
thermostat. A click will be heard from the On
switch, and the indicator light will go out.
15
2. 6. 1.
7.
5.
4.
8.
3.
9.
10.
11. 12. 13.
14.
IM 17/03/05 13:05 Side 15