MACKIE HRS150 - Manual (Page 10)

10
S M
SLAVE/MASTER
SLAVE
IN
MASTER
OUT
LEFT
IN OUT
RIGHT
IN OUT
FOOTSWITCH
*MAX OPEN CIRCUIT 24V
*MAX CLOSED CIRCUIT 1A
OPEN - SUB ON, L/R BASS MANAGED
CLOSED - SUB DEFEAT, L/R FULL RANGE
REMOTE INDICATOR
CROSSOVER
CROSSOVER
110Hz 55Hz
80Hz
SUB SAT
110Hz 55Hz
80Hz
SUB SAT
(MONO)
OUT IN
L
R
L
R
SUBWOOFER BYPASS
POLARITY &
INPUT SENSITIVITY ACTIVE
PROCESSED
SIGNAL
Frequencies below the crossover frequency
are sent to the subwoofer, and frequencies
above the crossover frequency are sent to the
LEFT and RIGHT OUTputs, which are con-
nected to the main/satellite speakers.
Set the crossover frequency to the lowest
frequency response rating of the main/satellite
speakers.
MASTER OUT/SLAVE IN
Balanced XLR and unbalanced RCA female
connectors are provided for the MASTER OUT/
SLAVE INputs. Use these for daisy-chaining two
HRS150s by connecting the
MASTER OUT jack
from the first subwoofer to the SLAVE IN jack
on the second subwoofer (see note below).
The SLAVE IN bypasses all filtering, but is
affected by the POLARITY and INPUT SENSI-
TIVITY settings.
The MASTER OUT is post-filtering (variable
and elliptical crossover, subsonic filter, and
LFE gain) and pre-
POLARITY and INPUT
SENSITIVITY.
Note: You cannot daisy-chain more than one
additional subwoofer using these connections.
If
SLAVE IN is used as an input, the MASTER
OUT has no signal present. To connect more
subwoofers, connect the
MASTER OUT from
the first subwoofer to the LEFT (MONO) INput
of the second subwoofer with the FILTER BY-
PASS switch pushed in. Then connect the
MASTER OUT of the second subwoofer to the
LEFT (MONO) INput of the third subwoofer,
and so on.
SUBWOOFER BYPASS FOOT SWITCH
This is a 1/4" jack for connecting a normally-
open footswitch. When the switch is closed, the
subwoofer is muted and the
LEFT and RIGHT
OUTputs pass the full-range signal to the
main/satellite speakers.
This is useful for making a quick compari-
son between the HRS150 enhanced and
non-enhanced low-frequency playback.
REMOTE INDICATOR
This is a 1/4" jack for connecting a remote
indicator to indicate when the subwoofer is by-
passed. An internal relay closes, shorting the
tip and sleeve of the
REMOTE INDICATOR
jack whenever the subwoofer is in bypass
mode, either triggered manually with the
FOOT SWITCH or by the auto-off function.
This can be used to turn on a remote, low-
voltage lamp. Note that this jack does not
provide power. It accepts a maximum of 24 VDC
120 VAC, 60 Hz,
950 WATTS
POWER
ON
across the tip/sleeve when the internal relay is
open, and a maximum 1 amp of current when
the relay is closed.
CAUTION: There is an in-
ternal 1A fuse to protect the
REMOTE INDICATOR circuit.
Exceeding 1A of current may
blow the internal 1A fuse.