Checking the programmed water hardness 16, Checking the programmed water hardness, Before using for the first time – Miele INCOGNITO G 818 SCVI User Manual
Page 16

15 - 70 gr/gal:
^ Press the f button.
The
f indicator will light.
An indicator corresponding to a preset
water hardness will light (see Table 2).
Table 2:
gr/gal
ppm
Button
15 - 16 270 - 280
a
17 - 21 300 - 370
b
22 - 24 390 - 430
c
25 - 31 450 - 560
d
32 - 70 570 - 1260
e
If this value corresponds with the water
hardness in your area:
^ Turn off the dishwasher.
If you need to program a different water
hardness:
^ Press the button which corresponds
to your water hardness (see Table 2).
The "Salt" and
b indicators will flash.
^ Press the f button twice.
The "Salt" and
f indicators will flash.
The new water hardness is set.
^ Turn off the dishwasher.
Checking the programmed water
hardness
^ Open the door.
^ Turn off the dishwasher.
^ Press and hold the a and c buttons.
At the same time turn on the
dishwasher with the "On" (15) button.
^ Release all buttons.
The "Salt" and
b indicators will flash.
If this is not the case, the above steps
must be repeated.
^ Press the b button.
The
b indicator will go out and the
"Salt" indicator will flash.
The programmed water hardness is
indicated by:
1 - 14 gr/gal
Corresponding indicator is lit, (see
Table 1).
^ If an indicator is not lit, press the f
button.
15 - 70 gr/gal
The
f indicator and an additional
corresponding indicator is lit (see Table
2).
^ Turn off the dishwasher.
Before using for the first time
16