Reset button additional feature, Area radio frequency adjustment, Reset button – Magnadyne LINEAR SERIES RV4000 User Manual

Page 17

The LCD display may fail to function normally
due to the vehicle’s battery condition, and could
require resetting the radio microprocessor if:

• The vehicle has been “jump started” from a

dead battery condition.

• The vehicle battery becomes very low and is

quick-charged.

• The vehicle battery is removed and replaced.

Should any of these conditions occur, simply

press and release the RESET button on the radio

front panel using the tip of a ball point pen. This

will reset the radio microprocessor to the origi-

nal factory settings. After pressing the RESET

button you should recheck to see if the radio

functions normally.

Reset Button

Additional Feature

AS/PS

SLP

ALM

DISP

DIM

PUSH

RESET

AV HEADPHONES

AUX

AM/FM

DISC

SPEAKER

Reset Button

Area Radio Frequency Adjustment:

Note: If operating the unit in the USA do not

change the area.

To Change the Area:
1. Press the AM/FM button and “rAdIO” appears

in the display.

2. Press and hold the VOL/TONE knob until

“SEtUP” appears in the display.

3. Press the

�

ll button and “US” or “OCEAn”

will be displayed.

4. Press the l

��

l button to change the

setting to “US” or “OCEAn”.

5. Press the

�

ll button to save the setting. The

unit will clear all the station settings. After wait-

ing a few seconds the unit exit programming.