Marantz ES7001 - Manual (Page 10)

8
ENGLISH
NAMES AND FUNCTIONS OF PARTS
⁄4
⁄5
⁄8
⁄9
⁄6
⁄7
¤0
¤1
7
Buttons used for a TV
Notes:
• Before using the remote controller for a TV,
set the preset code for the TV.
• For details on the operation of the TV, refer
to the instruction manual supplied with the
TV.
⁄4 TV POWER button
Press this button to turn on the TV or to set
it to standby mode.
⁄5 TV MUTE button
Press this button to mute the TV sound
temporarily. Press it again to restore the
sound.
⁄6 TV VOL + button
Press this button to increase the volume
of the TV.
⁄7 TV VOL – button
Press this button to decrease the volume
of the TV.
⁄8 Numeric (1-12) buttons
These buttons are used for direct TV
channel selection.
⁄9 CH (channel) + button
Press this button to scan forward through
the TV channels.
¤0 CH (channel) - button
Press this button to scan reverse through
the TV channels.
¤1 INPUT SELECT button
Press this button to switch between the TV
broadcast and a video input.
7
Preset code setting
T h e r e m o t e c o n t r o l c o d e s o f T V s o f
manufacturers other than Marantz are preset
in the supplied remote controller. To use
the supplied remote controller for the TV of
another manufacturer, enter the code in the
remote controller.
1. Check the four-digit code number of
your TV manufacturer in the preset code
number lists shown below.
2. While holding down the TV POWER button
⁄4 on the remote controller, press the
Numeric buttons ⁄8 to enter the four-digit
manufacturer’s code number.
Presetting the code number to the remote
controller is complete.
Notes:
• Some of the preset codes in the lists may
not be compatible with your TV.
• If your TV does not operate with the remote
controller after entering the preset code,
try to enter another code number of the
manufacturer.
• Some of the functions of the TV may not be
operable with the remote controller even
after entering the code.