Midland Radio XTC-200 - Manual (Page 4)

www.midXTC.com 3
English
François
Español
Recording
1. Move the RECORD switch forward. This turns the camera on.
2. The battery indicator will light from red to green. The SD card
indicator will light green. The record indictor will begin flashing
red after 8 seconds. This indicates the camera is capturing
video.
3. To stop recording, move the RECORD switch back to the
off position.
Note: The camera will continue recording for 3 seconds after
toggling the switch to the off position.
SD card LED
Status
Meaning
Green 100% - 33% available.
Orange 33% - 20% available.
Red
20% available or
no Micro SD card installed.
Flashing Red Cannot read the card.
Flashing Green
Indicates card has been
reformatted.
Memory Size HD Record Time SD Record Time
512 MB 6.5 Minutes 9.5 Minutes
1 GB 13 Minutes 19 Minutes
2 GB 26 Minutes 38 Minutes
4 GB 52 Minutes 76 Minutes
8 GB 104 Minutes 152 Minutes
16 GB 208 Minutes 304 Minutes
32 GB 416 Minutes 608 Minutes
Note: The camera automatically splits the video into 2 GB segments.
Getting to Know the XTC-200 Getting to Know the XTC-200
Battery
1. To insert the battery, push down the battery door latch on the right side of
the camera. Door will release. Push forward to remove.
2. Install Lithium-Ion battery.
3. Return battery door and click into place.
Micro SD Card
1. Open and fold down the back rubber cover.
2. Insert Micro SD card into slot observing proper direction (shown below).
3. Return rubber flap into place.
Battery Status
Indicator
Meaning
Solid Green Indicates full battery life
Blinking Green Battery is charging
Solid Red Indicates half battery life
Blinking Red* Indicates low battery life
No Light Battery is dead
*Note: When the red battery LED begins blinking, be prepared
to charge the battery because the camera will stop recording
at this point.