Melissa 640-132 - Manual (Page 25)

24 25 24 25
4. The filter consists of two sections, both
of which must be cleaned. Brush the
parts with a small brush and/or wash
them in tepid water. Add a little detergent
if necessary. Check the filter pad is
COMPLETELY dry before replacing in the
appliance. NEVER insert a wet filter into
the appliance.
5. Place the top part of the filter on the
bottom part, and place the filter in the dust
container. Press down the filter far enough
so that it fits tightly to the sides of the dust
container. The filter can only be fitted in
one position.
6. Mount the dust container by pressing it
firmly onto the motor section. Check that
the lock tab (8) on the motor section clicks
into place in the lock hole (0) on the dust
container so that the dust container is
firmly mounted on the motor section.
7. Replace the hand-held vacuum cleaner on
the appliance.
CLEANING
• Clean the appliance by wiping it with a
damp cloth. A little detergent can be added
if the appliance is heavily soiled.
• Never use a scouring pad, steel wool or
any form of strong solvents or abrasive
cleaning agents to clean the appliance, as
those may damage the outside surfaces of
the appliance.
• Clean the filter as described above. When
the filter pads are worn or cannot be
properly cleaned, replace them with pads
of the same type.
• Check that the dust container and the filter
are COMPLETELY dry before the appliance
is assembled and used again.
Cleaning the brush of the floor nozzle
There is a rotating brush in the floor nozzle.
The brush must be cleaned if it becomes
covered in hair or other substances.
. Switch appliance off.
2. Detach the floor nozzle from the appliance
by loosening the mounting screw at the
back of the connector on the floor nozzle
and sliding off the floor nozzle.
3. Turn the floor nozzle upside down so that
you can see the rotating brush.
4. Loosen all screws on the back of the floor
nozzle using a philips screwdriver and
separate the two halves of the floor nozzle.
5. Grab the two white plastic dowels (d) at
eiher side of the brush (f) and carefully lift it
off the floor nozzle.
6. Detach the belt (c) from the belt drives (b
and e).
7. Remove
hair, fibers
and dust
from the
brush.
8. Reattach
the brush:
First place
the belt
around the belt drive (e) of the brush, then
place the belt around the belt drive (b) of
the drive unit (a). Press the white dowels
firmly into the holders so that the brush
rests in the grooves.
9. Reattach the back of the floor nozzle so
that the screw holes fit together and press
it into position until a click is heard. Make
sure, the two parts fit tightly all the way
round.
0. Screw back all the screws.
INFORMATION ON DISPOSAL AND
RECYCLING OF THIS PRODUCT
Please note that this Adexi product is marked
with this symbol:
This means that this product must not be
disposed of along with ordinary household
waste, as electrical and electronic waste must
be disposed of separately.
In accordance with the WEEE directive, every
member state must ensure correct collection,
recovery, handling and recycling of electrical
and electronic waste. Private households in
the EU can take used equipment to special
recycling stations free of charge. In certain
member states, used apparatus can be
returned to the dealer where they were bought
on the condition you buy new products.
Contact your retailer, distributor or the
municipal authorities for further information on
what to do with electrical and electronic waste.