Murray 425620x92B - Manual (Page 31)

MAINTENANCE
31 F-040740L
HOW TO REPLACE THE MOWER DRIVE BELT
1. Remove the mower housing. See the instructions on “How To
Remove The Mower Housing”.
2. Pull the belt retainer away from the idler pulley and remove
the mower drive belt (Figure 35).
3. Pull the belt retainer away from the right mandrel pulley and
remove the mower drive belt.
4. Pull the belt retainer away from the left mandrel pulley and
remove the mower drive belt.
NOTE: Replace the mower drive belt with an original
equipment belt from an authorized service center.
5. Install the new mower drive belt. Pull the belt retainer away
from the right mandrel pulley. Put the belt around the right
mandrel pulley.
6. Pull the belt retainer away from the left mandrel pulley. Put
the belt around the left mandrel pulley.
7. Pull the belt retainer away from the idler pulley. Put the flat
side of the mower drive belt around the idler pulley.
8. Make sure the “V” side of the mower drive belt is against the
mandrel pulleys as shown.
9. Install the mower housing. See the instructions on “How To
Install The Mower Housing”.
10. Before you mow, check the blade rotation control. See the in-
structions on “How To Adjust The Blade Rotation Control”.
Figure 35 Mower Drive Belt
Belt Retainer
Right Mandrel Pulley
Belt Retainer
Left Mandrel Pulley
Idler Pulley
Belt Retainer