MGE UPS Systems EXB10Rack - Manual (Page 14)

10 Pulsar EX Rack: 86-153522-00 MGE UPS SYSTEMS
getting started
location
c observe the safety rules indicated at the
beginning of this document.
preliminary checks
c check that button 3 " " on the front is
not pushed in;
c check that rating shown on identification
plate 9 corresponds to the input voltage
specification and power requirement of your
application.
connections
c use your application cord to supply
input power to Pulsar as shown.
Connect the computer cord 5 between
UPS utility power receptacle
4 , and a
nearby utility power outlet. Note 1:
Following connection, the battery
automatically charges, whatever the position
of the ON/OFF button 3 "
" .
Note 2:
The batteries will provide full back-up time
after approximatively 8 hours of recharge
time.
Note 3:
The rating of input power cord must not be
less than the nominal input rating of
Pulsar EX10
Rack : Use the supplied cord.
c connection of Pulsar EXB10 Rack
battery extension module (optional):
v check that button 3 " " on the front of
the Pulsar EX10 Rack is not pushed in,
v disconnect the utility power connection
cord 5 ,
v flip the circuit-breaker 20 of the unit to
the right (position "O"),
v connect the battery connection cord 23
to connector 21 of the module and
connect 13 of the Pulsar EX10
Rack ,
v if the installation has 2 battery modules,
connect the second cord 23 to connectors
21 of the second module and 22 of the
first module,
v the use of connectors 13 , 21 and 22
is strictly limited to connecting the battery
modules to the Pulsar EX10
Rack . Any other
connection to these connectors is prohibited
at the risk of damaging the battery and
losing the warranty,
v flip the battery circuit-breaker 20 to the
left (position "I"),
v if your installation is operated with MGE
UPS SYSTEMS software, update your
battery configuration with EX Tuner.
c use IEC cords to connect your
applications to output sockets 7 .
7
Vac IN
computer
loads
utility
power
outlet
Vac IN
5
4