Miller Electric EXTREME 360 - Manual (Page 25)

OM-229 409 Page 21
5-2. Meter Functions
.
The meters display the actual weld output values for approximately three seconds after the arc is broken.
Mode Meter Reading At Idle Meter Reading While Welding
Scratch
Start TIG
V A
Actual Volts (OCV) Preset Amps
71.7 85
Actual Volts Actual Amps
V A
10.3 85
Lift-Arc TIG
Actual Volts Preset Amps
V A
14.1 85
Actual Volts Actual Amps
V A
10.3 85
TIG
Blank Preset Amps
V A
85
Actual Volts Actual Amps
V A
10.3 85
MIG
Preset Volts Blank
V A
24.5
Actual Volts Actual Amps
V A
24.5 250
Pulsed
MIG
Pulse Display Pulse Display
V A
PPP PPP
Actual Volts Actual Amps
V A
24.5 250
CC
Blank Preset Amps
V A
85
Actual Volts Actual Amps
V A
24.5 85
Stick
Actual Volts (OCV) Preset Amps
V A
71.7 85
Actual Volts Actual Amps
V A
24.5 85
V-Sense
Feeder
Flashes OCV And Preset Blank
V A
71.7
Actual Volts Actual Amps
V A
24.5 250
5-3. Mode Switch Settings
.
The Stick and CC modes provide the Adaptive Hot Start ™ feature, which automatically increases the output amperage at the start of a weld should
the start require it. This eliminates electrode sticking at arc start.
Mode Switch Setting Process Output On/Off Control Mode Switch Setting Process Output On/Off Control
Scratch Start TIG GTAW Electrode Hot
Lift-Arc TIG GTAW − See Section 5-4 Electrode Hot
TIG GTAW With HF Unit, Pulsing Device, Or Remote Control At Remote 14
MIG GMAW At Remote 14
Pulsed MIG GMAW-P (Requires an external pulsing device.) At Remote 14
CC Stick (SMAW) With Remote On/Off At Remote 14
Stick SMAW Electrode Hot
V-Sense Feeder MIG (GMAW) With Voltage Sensing Wire Feeder Electrode Hot