Mr. Coffee ZH User Manual

Page 5

COFFEEMAKER FEATURES AND BENEFITS

Your new MR. COFFEE

coffeemaker has the following features:

• Brewing Capacity – 12 Cups
• Coffee Dispensing Pedal – Drink coffee one cup at a time by dispensing

coffee directly into your cup instead of pouring from a coffee carafe.

• Sealed Coffee Chamber – Keep your coffee hot and fresh inside the sealed

coffee chamber and dispense it when you are ready.

• Removable Filter Basket – The filter basket pulls out for fast and easy

cleaning and filling.

• Pause ‘n Serve – Can’t wait for the coffee to finish brewing? The Pause

‘n Serve feature allows you up to 30 seconds to dispense a cup of coffee
while the coffeemaker is still brewing. Pressing a cup against the coffee
dispensing pedal will automatically activate the feature and temporarily
stop the flow of coffee into the coffee chamber.

• Removable Drip Tray – Any liquid overflow from your cup or drips during

dispensing will be caught in the drip tray. Be sure to empty and clean the
drip tray periodically. The drip tray has a snug fit to ensure it stays in place
during transit.

• Programmable Controls:

– Clock – The clock serves as a handy kitchen clock and allows you to set

the Delay Brew feature.

– Audible Signal – Alerts you at the end of a brew cycle.
– Delay Brew – Would you like to wake up to a fresh pot of coffee?

The delay brew timer allows you to preset when you would like the
coffeemaker to automatically begin brewing your coffee, up to 24 hours
in advance.

CLEAN YOUR COFFEEMAKER BEFORE

USING THE FIRST TIME

Make sure your first cup of coffee is as good as can be by cleaning your MR.
COFFEE

Coffeemaker before its first use.

1. Wash the coffee chamber, chamber lid, and brew basket with water and

mild detergent. Rinse each thoroughly (please refer to the parts diagram).

2. Replace all the parts and run a brew cycle with water only, without adding

coffee and coffee filter.

3. When brewing is complete, turn your coffeemaker off, discard the water in

the coffee chamber, and assemble your coffeemaker.

Your coffeemaker is now ready to use. Enjoy it!

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:

1. Plug the power cord into a standard electrical outlet.

The clock will flash on the control panel to indicate that
the time has not been set yet.

2. Press and hold the HOUR and MINUTE buttons until you

reach the current time. The PM indicator will light at the
top of the display (Figure 1).

The clock is now set!

NOTE: Pressing any button before setting the clock will cause
the clock to start keeping time from 12:00 a.m. You must set
the clock if you want to use the Delay Brew feature.

To Set the Delay Brew Time:

While the display is in the clock mode, simply press the SET
DELAY button (Figure 2) and, set the brew time by pressing
the HOUR and MINUTE buttons (Figure 3). The PM indicator
will light at the top of the clock display.

Within a few seconds the display will change to the
current time.

The Delay Brew Time is now set.

To activate the DELAY BREW:

1. Make sure the coffee chamber does not contain coffee

and is inserted properly into the coffeemaker.

2. Prepare your coffeemaker by adding water and

ground coffee.

3. Press the DELAY BREW button once. The coffeemaker

is now set to automatically brew at the pre-set time.

4. Cancel the DELAY BREW setting by pressing the DELAY BREW button

so the light turns off.

As a safety feature, your coffeemaker will NOT start again automatically
the next day. If you want your coffee to brew at the same time the
following day, simply add a new filter, coffee and water and set DELAY
BREW, by repeating Steps 2 and 3 above.

FIGURE 1

FIGURE 2

FIGURE 3