Grizzly G3619 - Manual (Page 20)

Figure 15. Positive stop.
Table Stop
Always disconnect
power to the machine
when making adjust-
ments. Failure to do this
may result in serious
personal injury.
The positive stop under the table ( see Figure 15)
allows you to repeatedly square up the table after
adjusting the table tilt. To adjust the positive stop
so the table will return perpendicular (90°) to the
blade after angle cutting
:
1. Make sure the bandsaw is unplugged!
-18- 24" & 27" Resaw Bandsaws
The blade guard is attached to the guide post
above the upper blade guide assembly. For prop-
er setup, the blade should be centered in the
blade guard.
To center the blade guard:
1. Loosen the hex bolt that secures the blade
guard bracket to the guide post.
2. Rotate the blade guard bracket in the appro-
priate direction until the blade guard is cen-
tered around the blade as illustrated in
Figure 14.
3. Tighten the hex bolt that secures the blade
guard bracket to the guide post.
Blade Guard
Figure 14. Blade centered in blade guard.
Blade
Blade
Guard