Grizzly HALOGEN LAMP H6441 - Manual (Page 2)

-2-
h6441 halogen lamp
If you need help with your new halogen lamp, call
our Tech Support at: (570) 546-9663.
Replacing bulb
1. turn the lamp OFF, unplug it from the power
source, then allow it to cool.
2. remove the three phillips head screws from
the lens retainer, then remove the retainer
(see
figure 2).
Like all high intensity lamps there is potential
danger when operating this lamp. Accidents
are frequently caused by lack of familiarity
or failure to pay attention. Use this lamp
with respect and caution to decrease the
risk of operator injury. If normal safety pre-
cautions are overlooked or ignored, serious
personal injury may occur.
3. While observing how the reflector and lens fit
into the lamp cavity, carefully remove them
from the lamp.
4. use clean gloves or a cloth to pull the bulb
from its receptacle and replace it with a new
one.
Note: Handling a halogen bulb with your
hands exposes the exterior quartz of the bulb
to oils and salts that could cause a weak
point and decrease the life of the bulb.
5. Make sure the reflector seal is positioned cor-
rectly on the reflector lip, then re-insert the
reflector back into the lamp cavity.
6. insert the lens on top of the reflector, then
secure them in place by re-installing the lens
retainer with the screws removed in
Step 2.
figure 2. lamp parts removed for bulb
replacement.
retainer
Bulb reflector
seal
lens