Genie SUPER HOIST 82297 - Manual (Page 9)

Part No. 82297 Genie Super Hoist 7
Fourth Edition • Second Printing Operator’s Manual
Platform Raise and Lower
9 Lock all four caster brakes.
10 Raise the platform by pressing the up button on
the hand control.
Result: Each tube should extend individually and
smoothly. They should not stick.
11 Lower the platform by pressing the down button.
Result: The platform should descend at a
smooth, controlled rate.
12 Raise the platform again and then lower it by
opening the manual dump valve on top of the
hand control.
Result: The platform should descend at a
smooth, controlled rate, but more quickly.
Note: Raising and lowering the platform twice,
without a load, lubricates the columns.
FUNCTION TESTS
6 Spin the pressure regulator connecting nut onto
the CO 2 tank valve stem and hand tighten. It is
not necessary to use a wrench.
Tip-over hazard. The pressure
regulator operating pressure is
preset for the maximum load
capacity of the machine. Modifying
or using any other pressure
regulator or compressor in excess
of 600 kPa / 90 psi service could
result in death or serious injury.
Use only Genie approved
replacement parts.
7 Connect the hose and hand control by inserting
the hose plug end into the coupling on the side
of the pressure regulator. Connect the hand
control hose to the valve at the base of the
cylinder assembly.
8 Open the CO 2 tank valve slowly by turning the
handle counterclockwise.
Component damage hazard. If the
CO
2 tank valve is opened quickly,
the pressure regulator diaphragm
could be damaged.