GE HO97796 - Manual (Page 2)

MULTIMEDIA SPECIFICATIONS ARE REQUIRED FOR FULL USE
OR MULTIMEDIA KEYS:
• IBM PC compatible system.
• Windows® operating system 95/98/ME/NT 4.0/2000.
• PS/2 or AT compatible keyboard port.
• CD-ROM drive (for CD and Video Operation).
• Standard sound card (optional for CD and Video Operation).
• MPEG card or pre-installed software MPEG (optional for video operation).
SPECIFICATIONS:
• Transmitter cable length: 5 ft.
• Transmission: infrared 38 KHz
• Transfer rate: 1200 bits per second
• Effective operating distance: approx. 12 ft.
• Effective operating angle: 120º
• Receiver LED indicator: num lock, cap lock, scroll lock, data indicator
• Weight: 2.42 lbs.
• Dimensions for keyboard: 18 1/2" x 7 1/2" x 2"
• FCC tested and approved
• Connection: 6 pin connector
• PS/2 connector
KEYBOARD INSTALLATION:
1. Before installation, be sure your computer‘s power is turned off.
2. Install three AAA batteries in the battery compartment on the back of your keyboard
(near the top).
3. Insert the 6 pin PS/2 connector attached to the receiver unit into your computers PS/2
keyboard port. If you have an AT port, you will need a PS/2 to AT adaptor (not included).
4. Place the receiver as desired facing the keyboard within the 120º angle limitations.
5. Power on your computer.
6. Standard keyboard functions should now work. For full multimedia/intellikey functions,
follow the instructions for software installation.
WINDOWS® 3.1x/DOS:
Windows® 3.1x and DOS do not have the ability to support the multimedia software and
intellikey functions. This keyboard will operate as a normal keyboard, but without the use
of multimedia functions.
1
= WAKE UPFROM SLEEP
Execute “system wake up” when the buttons are pressed. It wakes up/powers up
the system from the sleep mode. (In some cases, depending on the motherboard
you are using, the function “wake” can be used for both wake and power on).
TURBO KEY FUNCTIONS:
+ = 7 cursor repeat rates
Change from 2.5 CPS to 40 CPS (Default is in F4).
+ = Keyboard Lock
On/Off
6
Trouble Shooting:
If the standard keyboard functions are not working properly:
1) Check to make sure there is a secure connection to the PS/2 port.
2) Check to see that the batteries were properly installed. Fresh batteries provide
optimal performance.
3) Be sure the receiver is properly aligned to the keyboard. The keyboard needS to be
placed within a 120 degree angle and 12 ft. range of the receiver. The receiver should
be facing the keyboard and no obstacles should be obstructing the keyboard from
the receiver.
4) Check to make sure no other infrared device maybe causing interference.
If the multimedia/intellikeys are not working properly:
1) Be sure the software has been properly installed from the disk(s) which are labeled to
be compatible with your operating system.
2) Be sure there is no other keyboard software installed that maybe causing a conflict.
3) If the above steps are not effective, try uninstalling and then reinstalling the apropri-
ate software.