GN Netcom BT250v - Manual (Page 4)

6
En
g
lis
h
7
En
g
lis
h Pairing 3 will create a unique and encrypted wireless link between
two Bluetooth enabled devices such as your Bluetooth phone and Jabra BT250v.
1. Ensure the headset is off (see Turning
headset on/off section).
2. Press and hold until you see a solid
blue light (approximately 8 seconds), then
release* (see Fig. 2).
3. Set your Bluetooth phone to “discover”
the headset by following your phone’s
instruction guide. Typically, the steps
involve going to a “setup”, “connect”, or
“Bluetooth” menu on your phone and
then selecting the option to “discover” a
Bluetooth device.
4. Your phone will find the “Jabra BT250v”
headset and ask if you want to pair with it.
Confirm this by pressing “yes” or “ok”.
5. Enter passkey or PIN 4 = 0000 (4 zeros), then press “yes” or “ok”.
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing every 3 seconds. If unsuccessful, the light remains solid,
and you’ll need to reattempt pairing (see steps 3–5 above).
* If you have a Bluetooth phone that supports the hands-free Bluetooth profile,
see Enhanced features section for alternative pairing instructions. Phone-
specific pairing instructions can be found online at www.jabra.com/fscs
“Pair” to your Bluetooth phone 4
Fig. 2
Fig. 3
Turning headset on/off 6
BASIC OPERATIONS
What you do
Press and hold for 3 to
5 seconds until you see a
burst of flashes on the blue
indicator light, then release
Press and hold for 3 to
5 seconds until you see a
burst of flashes on the blue
indicator light, then release
What you hear
Ascending
(low-to-high)
tones
Descending
(high-to-low)
tones
Turning
headset on
Turning
headset off
What you see
The blue indicator
light will flash while
the power is on (see
Status indicators
table below)
The blue indicator
light will stop
flashing
Status indicators
What you hear
Quick series of 2 tones
– low to high pitch (when
active mode starts)
Quick series of 2 tones
– high to low pitch (when
standby mode starts)
3 beeps every 30 seconds
3 beeps every 5 minutes
Status
Active Mode 5
•
Call in progress
•
Up to 7 hours of talk-time*
Standby Mode 6
•
Waiting for call
•
Up to 200 hours of
standby time*
Low Battery (in active mode)
•
3 – 5 minutes of talk time left
Low Battery (in standby mode)
•
3 – 5 minutes of talk time left
What you see
Flashes every
second
Flashes every
3 seconds
3 flashes every
second
3 flashes every
3 seconds
* Depending on phone type and usage.
Turning on/off call alert vibrate 5
The Jabra 250v has a unique call alert feature that vibrates to inform you that you are
receiving a call. The vibrate function is enabled when you first turn on the Jabra 250v.
If you turn on the headset in the usual way without touching the volume button, the
vibrate function will remain enabled.
1. To turn off the vibrate feature, hold the volume-down button while you turn the
headset on.
2. If you wish to re-activate the vibrate feature, hold the volume-up button while you
turn the headset on.