GE 45601 - Manual (Page 13)

NOTE: The DTS and Time Zone Settings are reserved for future use.
NOTE: You will need to reprogram the Date and Time when the batteries are replaced.
EVENTS
The 45601 Advanced Remote allows you to program up to 15 automated
events such as turning on or off your lights at a preset time and day. You
must set the time and date before programming an Event.
Adding an EVENT:
Press and hold SETUP until the screen displays LGHT SETUP.
Use either Arrow key to scroll until the display reads EVENTS.
Press OK and the Screen will display ADD.
Press OK and the Screen will display EVERY DAY. Use Either Arrow
key to change this option to MON-FRI, SAT-SUN, ONE TIME or a
specific Day of the WEEK.
Once you have chosen the Event profile, press the OK key.
The Screen will now display SEL DIGIT.
Press any digit and the screen will display the EVENT number.
Press and release OK and the screen will display ENABLED.
PRESS OK and the Screen will display EVENT TYPE.
Use either arrow key to scroll between the
LIGHT, SCENE or
GROUP options (Pressing DIGITS 1-9 will adjust the LIGHT number
accordingly).
After you select the
EVENT type, press the OK key and the screen
will display ON TIME.
Pressing ON or OFF with the 1 key will adjust the hour.
Pressing ON or OFF with the 2 key will adjust the minutes.
Pressing ON or OFF with the 3 key will toggle between AM and PM.
Press the OK key once you have programmed the ON TIME and the
screen will display OFF TIME.
Pressing ON or OFF with the 1 key will adjust the hour.
Pressing ON or OFF with the 2 key will adjust the minutes.
Pressing ON or OFF with the 3 key will toggle between AM and PM.
Once you have programmed the OFF time press OK and the screen
will display SUCCESS.
Random EVENTS:
The 45601 Advanced Remote allows you to program automated events
such as turning on or off your lights at a predetermined time and day. By
choosing the
RANDOM option, the EVENT will start at +/-15 minutes of
the Scheduled Time.
To activate this function, after step 8 above, use either arrow key to scroll
until the display reads
RANDOM. Press OK and the Screen will display
EVENT TYPE. Continue the programming as shown in step 10 above.
Disabling an EVENT:
Once an event has been programmed, it can be disabled by following
steps 1-8 above and then scrolling to
DISABLED and pressing OK.
Deleting an EVENT:
Press and hold SETUP until the screen displays LGHT SETUP.
Use either Arrow key to scroll until the display reads EVENT.
Press OK and the Screen will display ADD.
Use either arrow key to scroll until the screen displays DELETE.
Press OK and the Screen will display SEL DIGIT.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
1.
2.
3.
4.
5.