Control settings, About the control settings – GE DBLR333 EN User Manual
Page 7
7
IMPORTANT: Clean the lint filter each time you use the dryer.
Fabric Care/Temperature
(on some models)
REGULAR For regular to heavy cottons.
or COTTONS
REG. HEAT
MEDIUM For synthetics, blends, delicates and items labeled permanent press.
or EASY CARE
MED. HEAT
DELICATES On some models. For delicates, synthetics and items labeled tumble dry low.
LOW HEAT
FLUFF For fluffing items without heat. Use the TIMED DRY cycle.
NO HEAT
Automatic cycles automatically determine fabric dryness. Select LESS DRY if you want your clothes
slightly damp at the end of the drying cycle. Select MORE DRY if you want them to feel drier. Timed
cycles run for a selected time.
Drying Cycles
COTTONS For cottons and most linens. For most loads select OPTIMUM DRY (on some models) or select the
Preferred Regular Setting marked with an *.
EASY CARE/ For wrinkle-free, permanent press and delicate items, and knits.
PERMANENT
PRESS
TIMED DRY Set the Cycle Selector at the desired drying time.
DAMP DRY For leaving items partially damp.
DEWRINKLE For removing wrinkles from items that are clean and dry or that are very lightly damp.
QUICK FLUFF For freshening or fluffing up already dry clothing, fabrics, linens, and pillows. Use with FLUFF NO HEAT.
Provides 10 minutes of no heat tumbling.
Start
—Close the dryer door. Select START. Opening the door during operation will stop the dryer.
To restart the dryer, close the door and select START to complete the cycle.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
1
2
3
About the control settings.
ge.com
Color Logic
(on some models)
Select the correct FABRIC CARE setting.
Match the particular color below the words
with the same color on the Cycle Dial.
Example: Drying a load of clothing labeled
permanent press.
Choose the FABRIC CARE setting-—for
this load it would be the EASY CARE
MED. HEAT (which is a particular color).
Turn the Cycle Dial to the area that has
the same color as the FABRIC CARE
setting you have chosen—for this load it
would be the EASY CARE AUTOMATIC.
2
1