Stovax 7118 - Manual (Page 12)

9.6 Using the stove with a damaged door seal could cause
dangerous fumes to enter the room, or the stove to overfire,
resulting in damage.
10.1 To maintain the safe use of your Stockton stove, you may
need to adjust the door hinges to ensure safe correct closing
of the door. Complete this operation as follows.
10. Open the door to give access to the fixed part of the door
hinge as shown.
10. Using a 19mm A/F spanner loosen the fixing nuts, as shown,
and reposition the hinge blocks to achieve a correct fit. This
may require a trial and error approach to find the correct
position.
1
8.6 Fit only Stovax ceramic glass, which is suitable to use in
high temperature applications.
8.7 Using the stove with a damaged door glass could cause
dangerous fumes to enter the room, or the stove to overfire,
resulting in damage.
9.1 To maintain the safe use of your stove you may need to
replace a damaged or worn door sealing rope. To complete
this operation, use this method.
9. Remove the door from the stove, by opening and lifting the
door free of the hinge blocks. Then lie the door face down
on a soft flat surface, to protect the paintwork and glass.
9. Remove the old rope and scrape old glue from the locating
groove. Clean the locating groove with a clean dry cloth to
remove all old dust and debris.
9.4 Squeeze a generous bead of fresh Stovax Thermic Seal glue
(Stovax Part No. 507) into the rope locating groove. Press
the new Stovax rope into the locating groove, placing the
joint in the middle of the lower edge of the door.
9.5 Refit the door and close the door to apply pressure to
new rope. Leave the stove closed for at least 1 hours
before lighting the stove and using at a low output for
approximately one day.
9. FITTING A NeW dooR SeAl
Joint
Seal 14mm
Seal 14mm
Seal 10mm x mm
MAINTeNANCe and SeRVICING
10. AdJUSTING dooR HINGeS
Fixing Nut Lock Nut
PR7084
PR7087 PR7086
PR7085
Single Door
Double Door