Graco Baby Carrier User Manual

Page 23

• Combination Lap/Shoulder

Belt with Sliding Latch Plate
This belt has a latchplate that

slides freely along the belt.
This belt MUST be converted to prevent

movement of the lap portion of the belt. You

must use the locking clip provided with the

infant restraint, unless your vehicle's seat belt

can be converted in another way as described

in your vehicle owner's manual.

To Install Locking Clip:
1. Tighten the buckled belt by pushing

down hard on the infant restraint and

pulling hard on the shoulder belt.

2. While pushing down on infant restraint,

pinch the two straps together behind

the buckle tongue. Unbuckle the belt

without allowing it to slip.

3. Connect lap and shoulder

belts with locking clip as

shown

and

4. Rebuckle belt. Check that

lap belt does not move by

pulling and pushing hard

on infant restraint. If belt

loosens or lengthens,

repeat procedure.

Locking clip

inch

Locking clip goes here,

inch from the buckle