Grundig 800 - Manual (Page 21)

CLOCK AND TIMER FUNCTIONS,
22
SETTING TIMER ON/OFF TIMES
Press and hold the button for approximately
2 seconds until the 'TIMER' annunciator turns on, and 'ON'
flashes. The 'ON' Time will also be indicated in the
frequency portion of the display (same readout format as the
clock) as well as the number '1' or '2' displayed to the right of
the time. The number '1' or '2' indicates which one of the two
event timers you are programming.
Press the desired 'Direct-Key-Input' buttons to enter a new
'ON' time. Enter the time in 'HH:MM' and in 24 hour format.
Press the button to remove the 'ON' time, to use the
timer as a Sleep timer. For a Wake timer, program an 'ON'
time and remove the 'OFF' time.
To set the 'OFF' time, press the button again to
display 'OFF' time.
Press the desired 'Direct-Key-Input' buttons to enter a new
'OFF' time. Enter the time in 'HH:MM' and in 24 hour format.
Press the '' button to remove the 'OFF' time, if desired.
Press the button again to enter TIMER 2 'ON'
time.
Press the button again to enter TIMER 2 'OFF'
time.
Finally, press the button to save the settings and
switch the display to normal readout values.
1)Example for Setting Timer '1'
With frequency displayed, suppose it is desired to set
Timer '1' for a local ON Time of '16:59' and an OFF Time
of ' 18:01'.
Action:
Press and hold the button for 2 seconds.
Press the button sequence
Press
Press the button sequence
Press
If it is desired to set 'Timer 2', use the same procedure as
that for 'Timer 1'. Otherwise,
Press , to exit the 'Setting Timer' operation
and return to normal frequency display.
ENABLING/DISABLING TIMER OPERATION
Press the button.
The 'TIMER' symbol will light in addition to either or both
the timer '1' or timer '2' indication. After 2 seconds with no
entry, the display reverts back to frequency readout. Timer
'1' can be disabled/enabled by pressing the '1' numeric
digit on the 'Direct-Key-Input' keypad while the timer
enable display is showing. Timer '2' can be
disabled/enabled by pressing the numeric digit '2' on the
'Direct-Key-Input' keypad while the timer enable display is
showing.
Prior to enabling either or both timers, consider one of two
possible cases for each timer:
eg.) -To Enable TIMER '1' –
(1) '-' is displayed: Press the button to display '1'.
(2) '1' is displayed: Press the button twice to again
display '1'.
It is important to note that the timer is enabled only when
the timer is deliberately changed from a '-' to a '11', or to a
'2'.
Even if the '1' or '2' is already displayed, the timer is not
enabled unless the '-' to '1' or '2' transition occurs.
Setting a '-' for either timer DISABLES the respective timer.