Grizzly Heavy-Duty Table G1023Z - Manual (Page 26)

-24- G1023Z Series Heavy-Duty 10'' Table Saw
5. If the blade splitter is to the right of the blade
as shown in
Figure 21 , simply add washers
between the splitter and the front mounting
bracket, and adjust the rear splitter support
as shown in
Figure 22 .
4. Next, set a straightedge against the face of
the saw blade and the blade splitter as
shown in
Figure 20. If the blade splitter is
properly aligned, please skip ahead to Page
26 ; otherwise, continue with the next step.
Figure 20. Guard in line with blade.
Figure 21. Improper splitter/blade alignment.
Splitter
Add washers
here to move
back of split-
ter to the left.
Add washers
here to move
front of split-
ter to the left.
Blade
Figure 22. Proper splitter/blade alignment.
Added Washers
Front Support
Bracket
Adjustment
Screw
Adjusted
Rear Splitter
Proper Alignment
Use caution and remain
alert when working
around the saw blade.
Failure to follow this
warning could result in
serious personal injury
or death.
!