Global Machinery Company RLMC - Manual (Page 11)

11
3. Sharp blades cut cleanly and efficiently, if the blade is dull
it will tear the grass. This will result in the ends turning
brown. When the blades no longer cut cleanly either
sharpen them or replace them.
4. To safely operate the mower ensure all four wheels are
on the ground and be careful not to loose your footing
or control of the mower. Be very careful when mowing
uneven or rough ground. Keep a firm grip on the handle
bar at all times, always walk, never run with the mower.
5. For healthier and greener grass do not cut it too short.
This can cause damage to the grass and allow weeds
to develop. Short grass will also require more watering.
6. Vary your cutting pattern from week to week, this will
help to prevent matting and graining of the grass.
7. Before checking a clogged mower deck stop the engine
completely and disconnect the spark plug lead and then
tilt the mower so the air filter side is facing upwards.
Use a stick the clear any clogged material, never use
your hands.
8. Mowing wet grass should be avoided. Wet grass will tend
to stay flattened by wheels and not actually cut it. It will
also clog the mower deck and if it is slippery you may
loose your footing.
9. Always mow across slopes not up and down them.
Be extra careful if the grass is wet as this could cause
you to slip and loose control of the mower.
10. If the ground is to dry, mowing will stir up a lot of dust
which may clog the air filter. It is recommended you
check and clean the air filter straight after mowing.
11. Use the side of the mower as a guide to cut close to
large objects such as a fence or a wall. Be careful when
mowing over obstacles embedded in the lawn such as
sprinkler systems and paving, avoid anything that sticks
up above the surface of the lawn.
12. Avoid mowing over loose stones, gravel and other
landscaping material as this can be picked up by the
mower and flung out causing serious personal injury.
13. If the blades do come into contact with something or the
mower starts to vibrate stop the engine immediately,
remove the spark plug lead and inspect to see if there
is any damage.
Emptying the grass catcher
To remove the catcher, raise the guard while lifting the
catcher to dislodge it from the hooks.
Do not leave clippings in the catcher for extended periods.
WARNING. Check the catcher frequently for cracks and
wear and replace it if damaged.
Maintenance
CAUTION. Before making any adjustment or maintenance
procedures to the mower ensure it is turned off and the
spark plug lead is removed.
WARNING. It is important that when the mower is tipped
backwards the spark plug is highest in the air. Failure to do
so will mean that oil will travel into other internal areas, this
can cause the mower to have difficulty starting, excessive
smoke and oil leaks. Such occurrences are not covered
under warranty.
Changing the mower blade
WARNING: Stop the engine and unplug the spark plug
before any repairs or maintenance operations.
The blade is made of pressed steel. In order to obtain a
clean cut, sharpen the blade periodically after every 25
hours of use. Ensure that the blade is always well balance.
A badly balanced blade can involve harmful vibrations and
may cause injury.
WARNING. Never carry out any assembly operations or
adjustments with the engine running.
1. Periodically check the blade for nicks and dull cutting
edges and have it sharpened if needed.
Note. The blade should be sharpened and balanced by
an authorised repair centre.
2. If there are rounded or broken ends, thinned metal or
other damage, replace the blade.