Global Machinery Company 25CC - Manual (Page 9)

9
• Mix only enough fuel for your
immediate needs. Do not store
the mixed fuel mixture.
Starting the brush cutter
Choke control
Start position (choke closed).
Run position (choke open).
1. Move the ignition switch (11) to
the on position marked with a
(Fig. L).
2. Move the choke lever (19)
upwards to the start position
(cold start) (Fig. M).
NOTE. This is not required if the
engine is warm.
3. Push the primer bulb 6 times,
until the petrol/oil mixture fills
the primer bulb (Fig. N).
NOTE. This is not required if the
engine is warm.
4. Pull the recoil starter (14)
several times until you hear
the engine starting (Fig. O).
5. Push the choke lever slowly
down to the run position
(warm start).
6. The engine may start or it may
require you to pull on the recoil
starter until the engine starts.
7. Allow the engine to run idle
for around 10 seconds to let
it warm up.
9. Squeeze the safety lever
(18) and throttle trigger
(13) to engage the blade or
spool (Fig. P).
Stopping the brush cutter
WARNING: The blade/spool will continue to rotate for a few
seconds after the engine has stopped.
1. Release the throttle trigger and
allow the engine to idle for a
few moments.
2. Move the ignition switch (11) to
the off position marked STOP
(Fig. Q).
3. The engine will now stop.
Running in the engine
1. During the first 2-3 hours of work, run the engine at a
moderate speed.
2. We advise you in any case not to maintain your engine at
a high speed as the different components must settle with
each other during the process of running in the engine.
3. It is at the end of the running in period that the engine will
reach its maximum power.
4. After the first two hours of work, stop and make sure that
all nuts and screws are securely fastened, and tighten
them if necessary.
Use of the brush cutter
This petrol brush cutter is designed to cut grass, small
bushes, and shrubs.
• Never operate the brush cutter without a properly
functioning muffler and spark plug cover installed.
• Always use the shoulder strap, when using the tool, to
avoid serious injury.
• Never operate the brush cutter unless it is properly
assembled and in good working condition.
• Perform a few accelerations of the motor without reaching
maximum speed and without working to make sure that
everything is in good working order.
• Start the engine only when you are close to the
working area.
M
L
N
O
P
Q