Grizzly G0636XB - Manual (Page 3)

Model g0636XB -3-
4. adjust the fence face parallel with the edge of
the miter slot, as shown in figure 7.
aligning fence
to ensure cutting accuracy when the fence is first
installed, the fence should be aligned with the
miter slot.
to align the fence parallel with the miter slot:
1. disConneCt BandsaW FroM poWer!
2. Make sure the miter slot is aligned with the
bandsaw blade (see g0636X Manual page
25, Aligning Table).
3. Mount the fence next to the miter slot, then
loosen the knobs and cap screw that secure
the fence rail to the table.
NOTICE
adjusting the fence parallel to the miter slot
does not guarantee straight cuts. the miter
slot may need to be adjusted parallel to the
side of the blade. refer to the "aligning
table" instructions in the g0636X manual
on page 25.
5. tighten the knobs and cap screw that secure
the rail to the table, being careful not to move
the fence.
figure 7. example of fence square with miter
slot.
7. try to turn the machine ON.
—if the bandsaw does not start, the switch
disabling feature is working as designed.
the test run is complete.
—if the bandsaw starts, immediately discon-
nect power. the switch disabling feature is
not working correctly. this safety feature
must work properly before proceeding with
regular operations. Call tech support for
help.
OFF Button
TWIST
figure 5. resetting the switch.
6. turn the switch disabling key to "0", as shown
in figure 4.
motor brake
the motor brake is activated automatically when
the oFF button is pushed, quickly bringing the
blade to a stop.
accessories
t10131—extension table for g0636Xb
easily attaches to the main table of your bandsaw
and provides additional support for large
workpieces.
figure 6. Model t10131 extension table
attached to g0636XB bandsaw.