Gold's Gym GACR02 - Manual (Page 5)

5
Assembly requires two persons. Place all parts of the CORNER BOXING RACK in a cleared area and remove
the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly
requires two adjustable wrenches (not included).
2
2
23
6
6
21
21
18
15
18
26
18
23
14
14
19
21
14
14
5
5
Assembly
1. Press a Large Plastic Cap (15) into the lower
end of the Lower Frame (2). Press a 50mm
Square Plastic Cap (14) into each Base (5, 6).
Hold the Left and Right Bases (5, 6) against the
Lower Frame (2) as shown. Attach the Bases to
the Lower Frame with an M10 x 70mm Bolt (18)
and an M10 Nylon Locknut (23). Do not tighten
the Nylon Locknut yet.
See the inset drawing. The CORNER BOXING
RACK is designed to be placed in the corner of
a room. If you do not plan to use the CORNER
BOXING RACK in a corner, the Rear Base (19)
should be attached. Position the Rear Base
against the Lower Frame (2) as shown. Attach
the Rear Base to the Lower Frame with the M10
x 95mm Bolt (26), an M10 Washer (21), and an
M10 Nylon Locknut (23). Do not tighten the
Nylon Locknut yet. Next, attach the Rear Base
to the Left and Right Bases (5, 6) with two M10
x 70mm Bolts (18), two M10 Washers (21), and
two M10 Nylon Locknuts (23). Do not tighten
the Nylon Locknuts yet. Press two 50mm
Square Plastic Caps (14) into the Rear Base.
1
M6 Nylon
Locknut (25)–6
M10 Nylon
Locknut (23)–17
M10 x 35mm Carriage Bolt (22)–4
M10 Washer
(21)–17
M6 x 30mm Bolt (24)–6
M10 x 63mm Carriage Bolt (27)–2
M10 x 15mm Screw (16)–8
M10 x 70mm Bolt (18)–5
M10 x 95mm Bolt (26)–1
M10 x 65mm Bolt (20)–4