Guardian Technologies PUREGUARDIAN H4500 - Manual (Page 4)

E-6 E-7
• Always unplug the unit before servicing it in any way.
• The water temperature of the water remaining in the unit after use may be high.
• Do not submerse the unit in the water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash
out the unit with fresh water using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft, damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside down with a soft cloth.
Do NOT use soap or detergents.
ULTRASONIC DISK
Remove the tank (Fig. 1) and use the enclosed cleaning brush to regularly remove
build up and deposits from the disk area (Fig. 2).
**Diluted white vinegar will help to prevent this build up.
(Fig. 1) (Fig. 2)
• Fully dry the inside and outside of the unit before storing it.
• DO NOT leave water in the unit.
• Store in a cool, dry place.
7. Turn the Humidity Dial to the
desired volume of humidity.
Turn towards the right and the
humidity level increases; turn
towards the left and the humidity
level decreases.
8. As soon as the Refill LED lights
up, the unit will shut off
automatically. Refill tank with
water and unit will automatically
continue running.
*Clean the disk with the
brush only. No other
cleaning tool should
be used. BRUSH ONLY.
(Fig. 2)
**DO NOT scrub or
scrape the ultrasonic
disk. Disk must be
cleaned gently, ONLY as
described in this manual.