Grizzly ULTIMATE 14" G0555P - Manual (Page 16)

-14-
model g0555/g0555p (mfg. Since 5/11)
Inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check the machine and the packaging
materials. Some of these items may be pre-
installed for shipping or become misplaced
during unpacking.
Shipping Inventory: (figures 4–6) Qty
A. Bandsaw Assembly .....................................1
B. Upper Stand Braces ....................................2
c. Stand top ....................................................1
D. miter gauge Assembly ................................1
E. Stand Sides .................................................2
f. table w/insert & table pin ..........................1
G. table trunnion .............................................1
h. table lock Knobs 3 ⁄
8
"-16 .............................2
I. lower Stand Braces ....................................2
J. Front Fence rail ..........................................1
K. rear Fence rail ..........................................1
L. Fence Assembly ..........................................1
M. hardware (not Shown):
— hex Bolts m6-1 x 16 (Stand) ................. 16
— Flat Washers 6mm (Stand) ................... 16
— Flange nuts m6-1 (Stand) .................... 16
— Stand Feet
3 ⁄
8
"-16 x 2" (Stand) ................ 4
— hex nuts 3 ⁄
8
"-16 (Stand Feet) .................. 8
— Flat Washers 3 ⁄
8
" (Stand Feet) ................ 8
— Carriage Bolts m8-1.25 x 16 (Stand) ...... 8
— Flange nuts m8-1.25 (Stand) .................. 8
— hex Bolts m8-1.25 x 35 (Bandsaw) ........ 4
— Flat Washers 8mm (Bandsaw) ............... 8
— lock Washers 8mm (Bandsaw) .............. 4
— hex nuts m8-1.25 (Bandsaw) ................. 4
— hex Bolts m8-1.25 x 30 (trunnion) ......... 2
— lock Washers 8mm (trunnion) ............... 2
— hex Bolt m8-1.25 x 80 (positive Stop) .... 1
— hex nut m8-1.25 (positive Stop) ............. 1
— Fence Stand-off m6-1 x 20 (Fence) ....... 1
— lock handle m8-1.25 x 20 (Fence) ......... 1
—Cap Screws m6-1 x 16 Black (Fence) .... 2
— hex Bolts m6-1 x 20 Black (Fence) ........ 2
— lock Washers 6mm Black (Fence) ......... 2
— Flat Washers 6mm Black (Fence) .......... 2
—hex nut m8-1.25 Black (Fence) .............. 1
— hex nut m6-1 Black (Fence)................... 1
figure 4. Bandsaw assembly.
A
figure 5. other components.
B
e
i
h
C
d
g
F
figure 6. Fence components.
J
K
l