Getting to know your corvette – GM 2006 Corvette User Manual
Page 16
Heated Seats
(if equipped)
There is one
heated seat
control button
for each seat
located on the
center console.
Off: Press the
bottom of the
button ( )
to turn the
system off.
High: Press the top of the button once
to turn the system on high.
Low: Press the top of the button twice
to turn the system on low.
See Section 1 of your Owner Manual.
Getting to Know Your Corvette
16
Seat Controls
Six-Way Power Seats
The power seat controls are located on
the outboard side of the seat cushion.
• Move the front of the control up or
down to adjust the front of the seat
cushion.
• Move the rear of the control up or
down to adjust the rear of the seat
cushion.
• Slide the control forward or rearward
to move the entire seat forward or
rearward.
Power Lumbar and Side Bolsters
(if equipped)
• Press the vertical lumbar switch for-
ward to increase support and rear-
ward to decrease support.
• Pull the horizontal side bolsters
switch up to move the wings of the
seatback in closer and push the
switch down to move the wings out.
Window Indexing
To provide a tight seal around each
door, the window will automatically lower
slightly when the door is opened and
then automatically rise fully when the
door is closed.
If battery power is disconnected, the
indexing feature must be initialized
after restoring power by performing the
following procedure:
1. Close the door.
2. Raise the window by pulling up the
switch.
3. Hold up the switch for three seconds
after the window is closed and then
release it.
4. Hold up the switch again for three
seconds and then release it.
See Section 2 of your Owner Manual.
• To signal a turn, move the lever all of
the way up or down. The arrow on
the instrument panel cluster will flash.
The turn signal will stop flashing
when the turn is completed.
See Section 3 of your Owner Manual.