Grizzly H8191 - Manual (Page 11)

H8191 3600 PSI Diesel Pressure Washer
-9-
Figure 3. Model H8191 accessory inventory.
A
B
C
D
H8191 Accessory Inventory (Figure 3) Qty
A. Chemical Hose ........................................... 1
B. Chemical Filter ........................................... 1
C. O-Ring Seal Kit .......................................... 1
D. Input Hose Filter ......................................... 1
E. Hose Adapter Male-to-Male (not shown) .. 1
Assembly
Refer to Figure 1 on Page 4 for identification of
components in the following steps.
To assemble the H8191:
1. Thread the spray gun wand into the spray
gun and tighten securely.
2. Connect the male end of the high pressure
hose to the pump output port.
3. Connect the high pressure hose quick coupler
to the spray gun.
4. Connect the female end of the input hose
onto the pump input port.
5. Connect the other end of the input hose to
a spigot providing at least 5 GPM, or to the
input hose filter, if drawing from a standing
water source.
Note: Depending on the spigot fitting type, you
may need to use the provided male-to-male
input hose adapter to connect the pressure
washer to this type of water source.