GIGABYTE AMD Socket 939 Processor Motherboard GA-K8NF-9-RH - Manual (Page 71)

Appendix - 71 -
English
To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure
10), where you should see detailed information about RAID mode, disk block size, disk model name,
and disk capacity, etc.
Figure 10
Figure 9
After that, the Array List screen displaying the RAID array you created will appear (Figure 9).
If you want to set the disk array as boot device, use the UP or DOWN ARROW key to select the array
and press B. The Boot section will show Yes.
To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears,
press Y to confirm or N to cancel. Press ENTER to return to the Array List screen.
To exit the NVIDIA RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen.
Now, you can proceed to install the SATA controller driver and operating system.
MediaShield RAID Utility Aug 4 2005
- Array List -
[Ctrl-X] Exit [ ] Select [B] Set Boot [N] New Array [ENTER] Detail
Boot Id Status Vendor Array Model Name
No 2 Healthy NVIDIA STRIPE 223.57G
Array 2 : NVIDIA STRIPE 223.57G
- Array Detail -
RAID Mode: Striping
Striping Width : 2
Striping Block: 64K
Adapt Channel M/S Index Disk Model Name Capacity
1 0 Master 0 ST3120026AS 111.78GB
1 1 Master 1 ST3120026AS 111.78GB
[R] Rebuild [D] Delete [C] Clear Disk [ENTER] Return