GE MONOGRAM ZIFP360NX - Manual (Page 2)

For answers to your Monogram, ® GE Profile ™
or GE ® appliance questions, visit our website
at ge.com or call GE Answer Center ® service,
800.626.2000.
110151 Specification Revised 10/09
Listed by
Underwriters
Laboratories
ZIFP360NX
GE Monogram ® 36" Built-In Professional All-Freezer
Dimensions and Installation Information
Cutout and Clearances for Multiple Product Installations
If you are installing two units, side by side, the installation
space must be 71-1/2" wide. Additional cutout width may be
required when side panels are used. Add side panel thickness
to the finished cutout to calculate rough-in width.
• The water and electrical locations for each product must be
located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply is
recommended for each product.
251Dia35
251Dia61
25"
Min. to
Wall
0"
25"
Min. to
Wall
130 ° Door Swing 130° Door Swing
Clearances for two products installed side-by-side with
right and left side hinges together
Allow 5" minimum between the two products to prevent
one door from striking the other. Use the WX14X99
adjustable door stop to reduce the factory set 130˚ door
swing and to allow pan removal.
NOTE: A unified grille
panel kit will NOT fit this installation.
Clearances for Multiple Single Door Installations
In a side-by-side installation of a left and right door swing
product, the inside trims touch at the front, with a 1" clearance
between the units at the rear. Order ZUGPP2 Professional
Unified Grille Panel Kit for one continuous grille panel.
ZUGPP2: For side-by-side installation of two
professional models. This kit provides a unified stainless
steel grille panel to span the width of two units.
For a complete food storage center, install a Monogram
All-Refrigerator and All Freezer side-by-side. For even
more capacity, install two refrigerators or two freezers.
5"