When to charge the tool – Global Machinery Company FQC54V User Manual
Page 8
8
When to charge the tool
•
New tools are shipped in a low charge condition and
must be fully charged before use. It takes approximately
90 seconds to fully charge the tool.
•
Charging the tool should not be undertaken casually.
Through the charging cycle monitor the tool and make
sure that screwdriver is charging. This can be done by
viewing the rising needle on the gauge on the charger.
Note.
You may use the screwdriver at any time. The
charging process does not have to be completed to use
the tool and short chargers will not harm the tool.
See also other documents in the category Global Machinery Company Tools:
- 300W (8 pages)
- ATBR1650K (16 pages)
- PEDG (16 pages)
- BG612HPL (13 pages)
- PFC46V (8 pages)
- DC18V (16 pages)
- 444B (8 pages)
- IW1000 (12 pages)
- GTX1850K (16 pages)
- DEC007EN (2 pages)
- BFPCF (16 pages)
- 360W MAGNESIUM ALLNAILER ACALN (7 pages)
- EDG3 (12 pages)
- GTX18250 (13 pages)
- BG200A (12 pages)
- DP250LS (16 pages)
- BG125A (13 pages)
- DEC006PSI (2 pages)
- 420W (6 pages)
- Magnesium MRHD1500CF (8 pages)
- DEC005GG (2 pages)
- LDP13F12 (20 pages)
- RHD1500 (12 pages)
- ALN18V (16 pages)
- ATIW1 (16 pages)
- BJ600 (16 pages)
- BJ110M (16 pages)
- 183T (12 pages)
- 3G12V (16 pages)
- LDP13B12 (17 pages)
- 300 Piece (1 page)
- SG18V (16 pages)
- MXR56 (12 pages)
- DEC002SD (2 pages)
- 25CC (16 pages)
- TRM18V (12 pages)
- MX1G100 (12 pages)
- DEC001SI (8 pages)
- CRHD950CF (2 pages)
- DEC004DC (16 pages)
- HG2000K (9 pages)
- 3BVSIPCF (16 pages)
- RC1200 (12 pages)
- MAG950HD (12 pages)