Technical data – Gardena 4046 User Manual
Page 7
27
GB
26
GB
Only original GARDENA Blade Bars with original fixing must
be used. Spare GARDENA parts can be obtained from your
GARDENA dealer or the GARDENA service department.
• 46 V / 46 VD / 46 VDA:
GARDENA Blade Bar
Art. 531211017
• 51 VDA:
GARDENA Blade Bar
Art. 504113301
Fault
Possible cause
Remedy
v Raise cutting height or
reduce mowing speed.
Cutting height too low for the
lawn or mowing speed too high.
v Have the blade bar replaced.
Blade bar blunt.
Lawn is not cleanly cut.
v Clean mower
(see 7. Maintenance).
If this does not rectify the
fault, contact GARDENA
Service.
Imbalance resulting from very
dirty blade bar.
v Have the blade bar
tightened again or replaced
by an authorised dealer
or GARDENA Service.
Blade Bar damage or blade
fixing on the engine shaft has
come loose.
Runs unevenly,
mower vibrates strongly.
v Have screws tightened by
an authorised specialist dea-
ler or GARDENA Service.
Screws on motor, its fixing or
on the mower casing loose.
Loud noises, mower rattling.
v Let the engine run for
about 3 min. until the oil
has evaporated.
Oil in the exhaust because
the mowr has been tipped
sideways.
A lot of engine smoke after
starting.
v Have the engine serviced
by GARDENA Service.
No motor oil in crankcase.
Piston and crankshaft bearings
have jammed.
Engine runs for a short time
but then suddenly stops with
a loud bang.
v Adjust Bowden cable of the
drive.
Bowden cable of the drive has
moved due to wear.
Drive does not start.
v Adjust Bowden cable of the
switch handle.
Bowden cable of the switch
handle has moved due to
wear.
Motor does not start.
v Raise cutting height or
reduce mowing speed.
Cutting height too low for the
lawn or mowing speed too high.
v Insert spark plug connector/
clean or replace spark plug.
Spark plug connector not
inserted / spark plug faulty.
v See 5. Operation “Starting the
mower with a warm engine”.
Wrong engine setting.
v Fill with petrol.
Petrol tank empty.
Engine does not start.
9. Technical Data
46 V
46 VD
46 VDA
51 VDA
(Art. 4044)
(Art. 4046)
(Art. 4047)
(Art. 4051)
Engine (cubic capacity)
Briggs & Stratton
Briggs & Stratton
Briggs & Stratton
Briggs & Stratton
450
550
675 ready start
675 ready start
(148 cm
3
)
(158 cm
3
)
(190 cm
3
)
(190 cm
3
)
Wheel drive
–
1 gear rear wheel
variable rear wheel variable rear wheel
Engine oil (tank volume)
SAE 30 (0,6 l)
SAE 30 (0,6 l)
SAE 30 (0,6 l)
SAE 30 (0,6 l)
Petrol
unleaded petrol
unleaded petrol
unleaded petrol
unleaded petrol
(min. 87 octane)
(min. 87 octane)
(min. 87 octane)
(min. 87 octane)
Cutting width
46 cm
46 cm
46 cm
51 cm
Cutting height
30 / 40 / 50 /
30 / 40 / 50 /
25 / 35 / 45 /
25 / 35 / 45 / 65 /
60 / 70 / 80 mm
60 / 70 / 80 mm
65 / 75 / 95 mm
75 / 95 mm
Height adjustment
central 6 x
central 6 x
central 6 x
central 6 x
Wheel sizes
190 / 210 mm
190 / 210 mm
190 / 280 mm
190 / 280 mm
Wheel bearing
ball bearing
ball bearing
ball bearing
ball bearing
Mulch function
incl. unit
incl. unit
incl. unit
incl. unit
Collection Bag volume
53 l
53 l
53 l
60 l
Weight
29,9 kg
32,1 kg
34,3 kg
37,5 kg
For lawn areas
up to approx. 500 m
2
up to approx. 800 m
2
up to approx. 800 m
2
up to approx. 1000 m
2
Water connection (cleaning)
Original GARDENA hose connection system
Working area related emission
characteristic value L
PA
1)
84 dB (A)
84 dB (A)
84 dB (A)
84 dB (A)
Noise level L
WA
2)
measured 95 dB (A) measured 95 dB (A) measured 95 dB (A) measured 97 dB (A)
measured / guaranteed
guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 98 dB (A)
Vibrations a
vhw
1)
< 5,0 m/s
2
< 5,0 m/s
2
< 5,0 m/s
2
< 5,0 m/s
2
Measuring method
1)
EN 836
2)
2000/14/EG
!
Manufacturer
"
Model
§
Product number
$
Maintenance lever
%
Serial number
&
Type
/
Engine Info
(
Weight
)
Sound power level
!
§
$
%
"
&
/
(
)
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.